В Bazar.BG от 26 юли 2021г.
Последно активен вчера в 17:56 ч.
29 обяви на потребителя
Meyer Sound UltraSeries P-1A Signal Processor → Обява 48069569
Meyer Sound UltraSeries P-1A Signal Processor
Състояние
Използвано
Доставка
Купувача
Meyer Sound P-1A
Meyer P-1A / Meyer P1A Control Electronics Unit
Input Type: Balanced (active), 47k ohms
Output Type: Push-pull (active), 200 ohms source impedance
Maximum Input/Output Level Unbalanced: >+20 dBu
Maximum Input/Output Level Balanced: >+26 dBu
Hum and Noise: 4<–90 dBV
Dynamic Range: 5>105 dB
Sense Input: 10K ohms true differential, opto-isolated
Driver Protection Circuitry Low Frequency: RMS Limiter
Driver Protection Circuitry High Frequency: RMS and Peak Limiter
Sense: Green LED
Limit: Red LED
Power: Green LED
Controls: Level Control, AC on/off switch, Lo Cut Switch
Balanced Input/Output: 3-pin XLR (A-3), 1⁄4″ RTS phone jacks
Sense Input: Banana jacks
Power: 120/240V AC, 50/60 Hz (internally switchable)
Meyer Sound P-1A is optimized for the UPM-1 and pre-aligned at the factory. The P-1A contains frequency response and phase response alignment circuitry. It also offers Meyer Sound exclusive SpeakerSense driver protection circuitry, incorporating both peak and RMS signal limiting.
SpeakerSense protects the UPM-1 loudspeaker components from damage due to overheating under high power conditions. This unique circuit continuously monitors the power applied to the UPM-1 drivers. It also limits the signal output when the safe operating limits of the drivers are exceeded. Until the onset of overload, the SpeakerSense circuitry has no effect on the signal.
Six stages of Meyer’s exclusive complementary phase equalization in the Meyer P-1A Control Electronics Unit give the UPM-1 flat frequency response with outstanding phase characteristics.
A single-channel device operating at line level, the P-1A is the final component in the signal chain before the amplifier.
Meyer P-1A / Meyer P1A Control Electronics Unit
Input Type: Balanced (active), 47k ohms
Output Type: Push-pull (active), 200 ohms source impedance
Maximum Input/Output Level Unbalanced: >+20 dBu
Maximum Input/Output Level Balanced: >+26 dBu
Hum and Noise: 4<–90 dBV
Dynamic Range: 5>105 dB
Sense Input: 10K ohms true differential, opto-isolated
Driver Protection Circuitry Low Frequency: RMS Limiter
Driver Protection Circuitry High Frequency: RMS and Peak Limiter
Sense: Green LED
Limit: Red LED
Power: Green LED
Controls: Level Control, AC on/off switch, Lo Cut Switch
Balanced Input/Output: 3-pin XLR (A-3), 1⁄4″ RTS phone jacks
Sense Input: Banana jacks
Power: 120/240V AC, 50/60 Hz (internally switchable)
Meyer Sound P-1A is optimized for the UPM-1 and pre-aligned at the factory. The P-1A contains frequency response and phase response alignment circuitry. It also offers Meyer Sound exclusive SpeakerSense driver protection circuitry, incorporating both peak and RMS signal limiting.
SpeakerSense protects the UPM-1 loudspeaker components from damage due to overheating under high power conditions. This unique circuit continuously monitors the power applied to the UPM-1 drivers. It also limits the signal output when the safe operating limits of the drivers are exceeded. Until the onset of overload, the SpeakerSense circuitry has no effect on the signal.
Six stages of Meyer’s exclusive complementary phase equalization in the Meyer P-1A Control Electronics Unit give the UPM-1 flat frequency response with outstanding phase characteristics.
A single-channel device operating at line level, the P-1A is the final component in the signal chain before the amplifier.
Преглеждания: 31
Още обяви в Bazar.BG
Цена:
115 лв
Изпрати съобщение
08XX XXX XXX
(покажи)
Потребител 3136108
В Bazar.BG от 26 юли 2021г.
Последно активен вчера в 17:56 ч.
В Bazar.BG от 26 юли 2021г.
Последно активен вчера в 17:56 ч.
Вход
Регистрация
