Спектрален анализатор tinySA → Обява 49420599

Спектрален анализатор tinySA
гр. Пловдив, Център Наблюдавай

Публикувана/обновена вчера в 12:17 ч.

Състояние
Използвано
Доставка
Лично предаване; Купувача
Преносим спектрален анализатор tinySA , 2.8-инчов сензорен екран, обхват 100kHz до 960MHz


Specification
User interface:

Display resolution 320*240 pixels
Screen diagonal 2.8"
16 bits per RGB pixels
Resistive touch control
Jog switch control
USB serial port control
Optional TTL USART port on the internal PCB
Linear power supply to avoid switching noise.
The input/output specification of the tinySA is split over the 4 modes

Low input mode spec:

Input frequency range from 100kHz to 350MHz (with some limitations down to 10kHz)
Input impedance 50 ohm when input attenuation set to 10dB or more.
Selectable manual and automatic input attenuation between 0dB and 31dB in 1 dB steps
Absolute maximum input level of +10dBm with 0dB internal attenuation
Absolute maximum short term peak input power of +20dBm with 30dB internal attenuation
Suggested maximum input power of +0dBm with internal attenuation in automatic mode
For best measurements keep input power below -25dBm
Input Intercept Point of third order modulation products (IIP3) of +15dBm with 0dB internal attenuation
1dB compression point at -1dBm with 0dB internal attenuation
Power detector resolution of 0.5dB and linearity versus frequency of +/-2dB
Absolute power level accuracy after power level calibration of +/- 2dB
Lowest discernible signal at 30MHz using a resolution bandwidth of 30kHz of -102dBm
Frequency accuracy equal to the selected resolution bandwidth
Phase noise at 30MHz of -90dB/Hz at 100kHz offset and -120dB/Hz at 1MHz offset
Spur free dynamic range when using a 30kHz resolution bandwidth of 70dB
Manually selectable resolution filters with a width of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.
On screen resolution of 51, 101, 145 or 290 measurement points.
Scanning speed of over 1000 points/second using largest resolution filters.
Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth
Spur suppression option for assessing if certain signals are internally generated or actually present in the input signal
After a small HW modification it is possible to Listen to the demodulated audio (AM only)
High input mode spec:

Input frequency range from 240MHz to 960MHz
Input impedance is frequency dependent and deviates from 50 ohm
As there is no input band filter, strong input signals outside the 240MHz to 960MHz range can cause distortion of the in band signals
Absolute maximum input level without attenuation of +10dBm
Input Intercept Point of third order modulation products (IIP3) of -5dBm with no internal attenuation
1dB compression point at -6dBm with no internal attenuation
Power detector resolution of 0.5dB and linearity versus frequency of +/-2dB
Absolute power level accuracy after power level calibration of +/- 2dB
Lowest discernible signal using a resolution bandwidth of 30kHz of -115dBm
Frequency accuracy equal to the selected resolution bandwidth
Spur free dynamic range when using a 30kHz resolution bandwidth of 50dB
Manually selectable resolution filters of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.
Optional 25dB to 40dB frequency dependent input attenuator. The power level error with this attenuator activated increases to +/- 10dB
On screen resolution of 51, 101, 145 or 290 measurement points.
Scanning speed of over 1000 points/second using largest resolution filters.
Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth
After a small HW modification it is possible to Listen to the demodulated audio
Low output mode spec:

Sine wave output with harmonics below -40dB of fundamental
Output frequency range from 100kHz to 350MHz
Level accuracy +/- 2dB over the whole output frequency range
Output frequency resolution either 156Hz below 47MHz output or 312Hz above 47MHz output
Output level selectable in 1dB steps between -76dBm and -6dBm
Optional AM, narrow FM and wide FM modulation with frequencies between 50Hz and 5kHz or slow sweep over selectable frequency span
Optional output level sweep over maximum the entire output level range
High output mode spec:

Square wave output
Output frequency range from 240MHz to 960MHz
Output frequency resolution either 156Hz below 480MHz output or 312Hz above 480MHz output
Output level selectable in variable increments between -38dBm and +9dBm
Optional narrow FM and wide FM modulation with frequencies between 50Hz and 6kHz or slow sweep over selectable frequency span
Reference generator spec:

Optional square wave output with fundamental at -26dBm connected to high input/output
Frequency can be set to 1MHz, 2MHz, 4MHz, 10MHz, 15MHz or 30MHz.
Battery spec:

Charging time max 1 hour on 500mA minimum USB port or USB charger

Преглеждания: 23
Другите търсят също
Препоръчани за теб