Продава се многофункционален тестер за електронни елементи LCR-T4 Mega328
→ Обява 56859436
Продава се многофункционален тестер за електронни елементи LCR-T4 Mega328 .
Тестерът измерва:
Съпротивления: 0.1ohm - 50Mohm (резолюция 0.1ohm)
Капацитети: 25pf -100,000 uf (резолюция 1pF)
Индуктивности: 10uH - 20H (резолюция 0.1mh)
Измерва ESR на кондензатори, диоди (и ценерови), PNP/NPN транзистори (BJT, JFET, MOSMOS), тиристори и други.
Захранва се с обикновена 9V батерия. Нов неизползван уред в отлично състояние. Включени са измерителни сонди и инструкция за работа с тестера. Цена 30 евро.
По-долу са показани повече подробности и реални снимки на уреда.
Specifications:
Automatic detection of NPN and PNP transistors, N-channel and P-channel MOSFET, diodes, dual diode, thyristors, transistors, resistors, Inductors, capacitors and other components,
Test ranges:
Resistance: 0.1ohm - 50Mohm (resolution 0.1ohm)
Capacitor: 25pf -100,000 uf (resolution 1pF)
Inductors: 0.01mh -20H (resolution 0.1mh)
1 - Using ATmega328 microcontroller.
2 - One button operation, Auto power off function to avoid unnecessary waste, saving battery power, improved battery life.
3 - Shutdown current is only 20nA, support battery operation.
4 - High test speed, valid component test: 2 seconds (except in the larger capacitor of large capacitance measurement also takes a long time, the measured time of one minute is normal)
5 - Automatic detection PNP and NPN bipolar transistor, N, P -channel MOSFET, JFET, diodes, dual diode thyristor SCR.
6 - Automatic detection pin layout.
7 - Current amplification factor of bipolar transistors and measuring the threshold voltage emitter junction.
8 - Darlington transistor may be identified by the amplification factor of the high threshold voltage and high current.
9 - For bipolar transistor, MOSFET protection diode testing.
10 - And measuring the threshold voltage of the MOSFET gate capacitance.
11 - For the above values 2UF capacitor equivalent series resistance (ESR) capacitor value measurements. Resolution of 0.01ohms and a two-digit numeric display
12 - LED detection diode forward voltage drop is much higher than normal. Dual LED detected as double diodes.
13 - Zener diode can be detected if the reverse breakdown voltage is less than 4.5V.
14 - Only one measurement to find full-bridge connection.
15 - Testing time is about two seconds, only capacitance and inductance measurements will take a long time.
16 - Software can set the number of measurements before the power is automatically turned off.
17 - Built-in self-test function with selectable clock frequency of 50Hz signal to check the accuracy and waits for a call ATmega328.
Using 9V 6F22 battery.
Преглеждания: 57
☆
☆
☆
☆
☆
Оценка 0 от глас.